This is a working overview of thymosin beta-4, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2026-02-13 and is reviewed periodically as new material appears.
Thymosin beta-4 itself is a small, widely expressed protein that sequesters monomeric actin and participates in cell migration, angiogenesis, and tissue repair. Researchers have examined the shortened fragment as a possible mimic of some of these activities, reasoning that the actin-binding motif lies within the first few residues. Binding to monomeric actin has been observed in cell-free systems. Whether the fragment reproduces the broader effects of the full protein in living tissue remains an open question, and findings from animal models are frequently cited without a clear bridge to human physiology.
Discussion of TB-500 appears in several distinct literatures that rarely cite one another. Peer-reviewed studies usually describe in vitro assays or small animal experiments and are cautious about extrapolation. Veterinary and sports communities circulate anecdotal reports with limited methodological detail. Commercial listings add a third layer, often using the name interchangeably with thymosin beta-4 even though the two molecules differ in size and sequence. Regulatory status varies by country, and the compound is not a licensed medicine in most jurisdictions, so readers comparing sources should check which molecule and which purity each source actually describes.
TB-500 is a synthetic seven-residue peptide whose sequence, LKKTETQ, matches the N-terminal actin-binding region of thymosin beta-4. It is usually supplied in an N-terminally acetylated form, a modification that blocks the free amino terminus and can influence behavior in solution. In the research literature the same sequence appears under several names, including thymosin beta-4 fragment and shortened thymosin beta-4. Because it is a short peptide rather than the full 43-residue parent protein, its measured properties differ from those reported for thymosin beta-4 as a whole, and the two are not interchangeable in experimental design.
Lyophilised peptide is normally reconstituted with sterile water or a neutral buffer shortly before use. Because repeated freeze-thaw cycles can degrade the material, dividing a reconstituted solution into single-use aliquots is a common practice. Working solutions are usually kept cold and protected from light. The exact shelf life depends on concentration, buffer composition, and handling, so it is often determined empirically rather than assumed.
Peptide bonds are susceptible to hydrolysis under extreme pH and to enzymatic cleavage if proteases are present. Heat, oxidising agents, and prolonged exposure to light also contribute to loss of material. Aggregation can occur at high concentrations or in certain buffer systems, and it may not be visible to the eye. Storage at -20 C or below is typical for both powder and aliquoted solutions, and desiccation of the powder is preferred.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography together with mass spectrometry. The chromatogram provides a purity estimate as a percentage of total peak area, while the mass spectrum confirms that the observed mass matches the expected value. Amino acid analysis or tandem mass spectrometry sequencing can provide additional confirmation. Reported purity figures depend on the column, gradient, and detection wavelength, so values from different laboratories are not directly comparable without method details.
| Property | Value | Notes |
|---|---|---|
| Molecular class | Synthetic peptide | N-terminal fragment of thymosin beta-4 |
| Residue count | Seven | Sequence LKKTETQ |
| Approximate mass | 889 Da | Acetylated seven-residue peptide |
| Common synonyms | TB4 fragment, TB500 | Not identical to full-length TB4 |
| Reported activity | Actin binding | Observed mainly in cell-free systems |
TB-500 is a short synthetic peptide sold under a trade name rather than a systematic chemical name. Suppliers usually describe it as a fragment of thymosin beta-4 and ship it as a lyophilised powder intended for laboratory use. Because the label is commercial, the exact sequence attributed to it is not fully consistent across catalogues, and some listings present a seven-residue peptide while others describe related fragments of similar length. It is not an approved medicine in any major jurisdiction, and it is handled as a research chemical.
Thymosin beta-4 itself is a natural peptide of 43 residues found in many cell types and body fluids. Its best-characterised function is binding and sequestering actin monomers, which influences cytoskeletal dynamics. The sequence most often associated with TB-500, LKKTETQ, corresponds to part of that actin-binding region. A different fragment, Ac-SDKP, is also derived from the same parent peptide and is studied in its own right, which is one reason discussions of thymosin fragments can become confusing. The two are structurally distinct and are not interchangeable.
Interest in the fragment grew during the 1990s and 2000s, when it moved from laboratory work into sports and supplement markets. Anti-doping bodies added thymosin beta-4 fragments to prohibited lists, and a small number of adverse analytical findings have been reported in competition testing. Published controlled human trials remain scarce. Most mechanistic evidence comes from cell culture and animal models, and those studies examine endpoints such as cell migration, wound closure and inflammation markers. That evidence supports research interest but does not establish clinical benefit, and broad regenerative claims should be read as unverified.
Published research on the intact protein is substantial, covering actin regulation, cell migration, and wound models. Research using the heptapeptide fragment specifically is far smaller, and much of the circulating material originates in supplier documentation rather than peer-reviewed reports. Where fragment studies do exist, they often employ different sequences, chain lengths, or terminal modifications, which complicates direct comparison across papers. Readers encountering claims about TB-500 should therefore separate evidence about thymosin beta-4 from evidence about the fragment itself.
Discussion of the compound frequently appears alongside other short peptides described as fragments of larger proteins. That grouping is convenient but can be misleading, because fragment length, charge, and modification state determine how a peptide behaves in solution and in any experimental system. A seven-residue acetylated peptide and a full-length protein differ in mass by roughly an order of magnitude, and they cannot be assumed to share distribution or binding properties. Precision about which molecule is under discussion is the single most useful step when reading such material.
Purity is normally assessed by reversed-phase HPLC, with the main peak reported as a percentage of total peak area, while identity is confirmed by mass spectrometry. Electrospray and MALDI-TOF instruments are both used, and the observed mass is compared with the value calculated from the stated sequence. Ion-exchange or size-exclusion methods appear where aggregation or charge variants are of interest. Water content, counter-ion content and residual trifluoroacetate from purification are separate variables that can shift the measured mass and should be weighed when reading a certificate of analysis.
Research peptides are typically supplied as a white to off-white lyophilised powder in a sealed vial. The dry solid is more stable than a solution and is normally kept refrigerated or frozen until use. Dissolution is usually done in water, phosphate-buffered saline or a similar aqueous medium, depending on the assay. Because the material is hygroscopic and easily contaminated, opening vials in a low-humidity environment and recording the lot number before use are standard laboratory practices.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
== External links == AccelrysPKA — Accelrys CHARMm based pKa calculation H++ — Poisson–Boltzmann based pKa calculations MCCE2 — Multi-Conformation Continuum Electrostatics (Version 2) Karlsberg+ — pKa computation with multiple pH adapted conformations PETIT — Proton and Electron TITration GMCT — Generalized Monte Carlo Titration DEPTH web server — Empirical calculation of pKa values using Residue Depth as a major feature
Officers / Ceremonial dress (מדי שרד madei srad) – worn by officers, or during special events/ceremonies. Dress uniform and mess dress – worn only abroad. There are several dress uniforms depending on the season and the branch. The service uniform for all ground forces personnel is olive green. The uniforms consist of a two-pocket shirt, combat trousers, sweater, jacket or blouse, and shoes or boots. The green fatigues are the same for winter and summer and heavy winter gear is issued as needed. Women's dress parallels the men's but may substitute a skirt for the trousers. Headgear included a service cap for dress and semi-dress and a field cap or "Kova raful" bush hat worn with fatigues. IDF personnel generally wear berets in lieu of the service cap and there are many beret colors issued to IDF personnel. Paratroopers are issued a maroon beret, Golani brown, Givati purple, Nahal lime green, Kfir camouflage, Combat Engineers gray. Other beret colors are: black for armored corps, turquoise for artillery personnel. For all other ground personnel, except combat units, the beret for men was green and for women, black. In combat uniforms the Orlite helmet has replaced the British Brodie helmet Mark II/Mark III, RAC Mk II modified helmet with chin web jump harness used by paratroopers and similar to the HSAT Mk II/Mk III paratrooper helmets, US M1 helmet, and French Modèle 1951 helmet – previously worn by Israeli infantry and airborne troops from the late 1940s to the mid-1970s and early 1980s.
== Health risks == Acrolein is toxic and is a strong irritant for the skin, eyes, and nasal passages. The main metabolic pathway for acrolein is the alkylation of glutathione. The WHO suggests a "tolerable oral acrolein intake" of 7.5 μg per day per kg of body weight. Although acrolein occurs in French fries (and other fried foods), the levels are only a few μg per kg, meaning that one would have to consume more than their body weight in fries every day to surpass the limit set by the WHO. In response to occupational exposures to acrolein, the US Occupational Safety and Health Administration has set a permissible exposure limit at 0.1 ppm (0.25 mg/m3) at an eight-hour time-weighted average. Acrolein acts in an immunosuppressive manner and may promote regulatory cells, thereby preventing the generation of allergies on the one hand, but also increasing the risk of cancer. Acrolein was identified as one of the chemicals involved in the 2019 Kim Kim River toxic pollution incident.
Sources: en.wikipedia.org
In horticulture, lime sulfur (lime sulphur in British English; see American and British English spelling differences) is mainly a mixture of calcium polysulfides and thiosulfate (plus other reaction by-products such as sulfite and sulfate), formed by reacting calcium hydroxide with elemental sulfur, and is used in pest control. It can be prepared by boiling a suspension of poorly soluble calcium hydroxide (lime) and solid sulfur in water, together with a small amount of surfactant to facilitate the dispersion of these solids. After elimination of residual solids (flocculation, decantation, and filtration), it is normally used as an aqueous solution, which is reddish-yellow in color and has a distinctive offensive odor of hydrogen sulfide (H2S, rotten eggs).
== Further == Reece J, Urry L, Cain M, Wasserman S, Minorsky P, Jackson R (2011). "Chapter 4&5". In Berge S, Golden B, Triglia L (eds.). Campbell Biology. Vol. Unit 1 (9th ed.). San Francisco: Pearson Benjamin Cummings. ISBN 978-0-321-55823-7.
In practice, PCR can fail for various reasons, such as sensitivity or contamination. Contamination with extraneous DNA can lead to spurious products and is addressed with lab protocols and procedures that separate pre-PCR mixtures from potential DNA contaminants. For instance, if DNA from a crime scene is analyzed, a single DNA molecule from lab personnel could be amplified and misguide the investigation. Hence the PCR-setup areas is separated from the analysis or purification of other PCR products, disposable plasticware used, and the work surface between reaction setups needs to be thoroughly cleaned. Specificity can be adjusted by experimental conditions so that no spurious products are generated. Primer-design techniques are important in improving PCR product yield and in avoiding the formation of unspecific products. The usage of alternate buffer components (such as DMSO to help denature DNA) or polymerase enzymes can help with amplification of long or otherwise problematic regions of DNA. For instance, Q5 polymerase is said to be ≈280 times less error-prone than Taq polymerase, and more processive. Both the running parameters (e.g. temperature and duration of cycles), or the addition of reagents, such as formamide, may increase the specificity and yield of PCR. Computer simulations of theoretical PCR results (Electronic PCR) may be performed to assist in primer design.
Sources: en.wikipedia.org
No. Thymosin beta-4 is a 43-residue protein, while TB-500 refers to a seven-residue fragment corresponding to its N-terminal region. The two names are often used loosely in commercial and community writing, which obscures the difference in size, sequence, and likely behavior.
The fragment contains an actin-binding motif, and cell-free experiments show that it can interact with monomeric actin. That observation is the basis for interest in cell migration and repair processes. Effects reported in animals are not established for humans.
Purity is usually stated by the supplier rather than fixed by a pharmacopoeial monograph, and typical listings report a percentage from reverse-phase HPLC. Independent verification is uncommon. Because no single accepted specification exists, comparisons between lots and between suppliers are difficult.
The lyophilised powder is typically held at -20 C or lower in a dry, dark place. Reconstituted solutions are aliquoted and frozen to avoid repeated freeze-thaw cycles.