actin-binding fragment raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
Reviewed 2026-06-11. Anything still debated is marked as such rather than presented as settled.
TB-500 is a shorthand label used in supplier catalogs and online discussion for a short synthetic peptide described as a fragment of thymosin beta-4. Most product listings present it as the N-terminally acetylated heptapeptide Ac-LKKTETQ, a sequence corresponding to the actin-binding region of the parent protein. The name is not a formal chemical designation and does not appear in standard nomenclature systems. Because labeling practices vary between vendors, two products sold under the same name may not contain the same molecule, and the stated sequence should be treated as a claim rather than a fixed definition.
Thymosin beta-4 is a naturally occurring protein of 43 amino acids found in most mammalian cells, where it binds actin monomers and influences filament dynamics. It was first isolated from thymus tissue in the early 1980s, and its actin-binding activity was later mapped to a short region near the N-terminus. The synthetic fragment sold as TB-500 was designed to reproduce that region rather than the full protein. Whether a short fragment reproduces the behavior of the intact molecule remains an open question, since the parent protein carries additional structural elements outside the binding region.
Lyophilized peptide powder is normally held desiccated at −20 °C, with −80 °C used for longer storage periods. Allowing a sealed vial to reach room temperature before opening is standard practice, because condensation forming on cold powder introduces moisture. Once dissolved, solutions are typically kept cold and shielded from light. Repeated freeze-thaw cycles are avoided because they encourage aggregation and gradual loss of material. These conventions are general to synthetic peptides rather than unique to any one sequence.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
The regulatory position is broadly consistent across major jurisdictions: no thymosin beta-4 fragment is an approved medicine, and laboratory material is commonly labelled as not intended for human consumption. Anti-doping rules in sport list thymosin beta-4 and its fragments among prohibited peptide hormones. Because these products travel through research-chemical channels rather than pharmaceutical supply chains, quality varies considerably between vendors. Independent testing of identity, purity and sterility is the only dependable check, and a certificate of analysis describes one batch rather than a supplier's whole catalogue.
| Property | Value | Notes |
|---|---|---|
| Reported sequence | Ac-LKKTETQ | Described in most listings as the actin-binding region of thymosin beta-4 |
| Reported molecular weight | Approximately 889 Da | Value shifts with the stated sequence; compare against the certificate of analysis |
| Parent protein length | 43 amino acids | Thymosin beta-4; the fragment covers only a small part of it |
| Common synonyms | TB4 fragment; thymosin beta-4 fragment | Trade-style names rather than formal nomenclature |
| Formal monographs | Not established | Labeling conventions differ by supplier and region |
Lyophilized TB-500 is hygroscopic and should be kept dry before use. The usual storage recommendation for the solid is -20 °C, protected from light and moisture. Once dissolved, the peptide is less stable, and repeated freeze-thaw cycles can promote aggregation or degradation. Laboratories often divide a reconstituted solution into single-use aliquots and store them at -80 °C. Exact stability limits depend on buffer, pH, and concentration, so published data do not define a single universal condition.
Identity and purity are checked with chromatographic and mass spectrometric methods. Reverse-phase high-performance liquid chromatography separates the peptide from related impurities, while mass spectrometry confirms the expected molecular mass. A certificate of analysis may report a purity percentage, but the laboratory should still verify the material independently. Common quality concerns include truncated sequences, deamidation, oxidation, and residual solvents from synthesis. Because TB-500 is short, some impurities can differ from the target by only a few mass units.
Dry powder is commonly held at minus twenty degrees Celsius, with some suppliers recommending lower temperatures for long-term archival storage. Once dissolved, solutions are typically kept cold and protected from light, since aqueous peptide solutions can lose integrity through hydrolysis or oxidation over time. Stability data specific to this fragment are limited in the public literature, and much of the guidance comes from general peptide handling practice rather than from controlled degradation studies. Users therefore treat stated shelf lives as approximate rather than fixed.
Identity and purity are normally assessed with reversed-phase high-performance liquid chromatography, paired with mass spectrometry to confirm molecular mass. A certificate of analysis reports a purity percentage, usually derived from chromatographic peak area, but that figure does not by itself prove a correct sequence or the absence of counterions. Independent verification may include amino acid analysis or peptide mapping. Batch-to-batch variation is a documented concern in the research chemical market, and the gap between a quoted purity value and actual peptide content can be substantial when the material is a salt or retains residual water.
Identity and purity are assessed with a small set of standard techniques. Reverse-phase high-performance liquid chromatography gives a purity estimate from peak area, usually recorded at 214 or 220 nanometers, where the peptide bond absorbs. Mass spectrometry confirms the expected molecular mass and can reveal truncated or oxidized species. Amino acid analysis or tandem mass spectrometry sequencing can verify the sequence itself. Additional quality attributes include water content, residual trifluoroacetic acid carried over from purification, and endotoxin where the material is intended for biological work.
The compound is most often distributed as a lyophilized powder, appearing white to off-white and forming a loose cake or fluffy solid. It is hygroscopic to some degree, so brief exposure to humid air can add water weight and complicate weighing. The peptide dissolves readily in water and in neutral aqueous buffers, and aqueous solubility is generally described as high, well above the concentrations used in typical assays. Some polar organic solvents are also usable, which matters when a concentrated stock is prepared before dilution into buffer.
Storage recommendations center on keeping the dry powder cold, dry, and dark. A freezer at -20 degrees Celsius or below is conventional, and desiccant is often included to limit moisture uptake. Once dissolved, the peptide is less stable, and solutions are typically kept frozen and thawed only once. Repeated freeze-thaw cycles are a common source of losses because they promote aggregation and adsorption to container surfaces. Working aliquots are therefore prepared in advance, and glass or low-binding plastic is usually preferred over ordinary laboratory plastic.
Lyophilised material is stable for extended periods when kept dry and cold, and suppliers typically recommend storage well below freezing. Once dissolved, the peptide is handled at refrigeration temperatures and used within a short period, because peptide bonds and the acetylated terminus can be affected by repeated freeze-thaw cycles, proteases, or extreme pH. Bacteriostatic water and saline are both described as solvents, although preservatives can interfere with some analytical workflows. Reconstituted solutions are inspected for particulates before use.
Sports authorities classify the peptide as a prohibited substance, and it appears on the World Anti-Doping Agency list under peptide hormones, growth factors, and related substances. Racing jurisdictions for horses and dogs have issued separate restrictions, and several national bodies treat it as a controlled or prescription-only item. As a research chemical it is sold without a therapeutic indication, and labels usually state that the product is not for human or veterinary use. Regulatory treatment therefore varies by country.
==== MeSH E05.196.941 – ultracentrifugation ==== MeSH E05.196.941.336 – centrifugation, density gradient MeSH E05.196.941.336.253 – centrifugation, isopycnic MeSH E05.196.941.336.419 – centrifugation, zonal
Treatment of macrophages with lipopolysaccharide (LPS), a major component of the Gram-negative bacteria outer membrane, results in elevated O-GlcNAc in cellular and mouse models. During infection, cytosolic OGT was de-S-nitrosylated and activated. Suppressing O-GlcNAc with DON inhibited the O-GlcNAcylation and nuclear translocation of NF-κB, as well as downstream induction of inducible nitric oxide synthase and IL-1β production. DON treatment also improved cell survival during LPS treatment.
In 2019, the European Medicines Agency's Pharmacovigilance Risk Assessment Committee (PRAC) reviewed evidence on fluvoxamine as part of its class-wide signal assessment and recommended that product labels for all SSRIs and SNRIs be updated to state that sexual dysfunction may be long-lasting even after treatment is stopped. Health Canada followed with similar label updates in 2021. In 2024, Australia's Therapeutic Goods Administration aligned all SSRI and SNRI product information to reflect this risk; fluvoxamine was among the products requiring updated warnings.
Sources: en.wikipedia.org
=== Drugs === The anti-diabetic medication pioglitazone was shown in a mouse model of ALD to be effective at treating the metabolic effects of ALD, including metabolic failure and increased oxidative stress. Pioglitazone was also shown to prevent axonal degeneration and increase mitochondria levels, as well as stop the progression of locomotor decline in ALD model mice. Subsequently, the experimental drug leriglitazone has been developed as a more brain penetrant metabolite of pioglitazone. As of 2023, leriglitazone is in phase 2/3 clinical trials for adult and childhood cALD in the USA and the EU, and has completed a clinical trial for AMN.
The New Zealand-founded and California-based Rocket Lab had recently acquired the Arizona company Geost, which is involved in the Golden Dome project. Russia: Russian Foreign Ministry spokeswoman Maria Zakharova said "the United States' Golden Dome project undermines the foundations of strategic stability as it involves the creation of a global missile defense system." On 8 May 2025, China and Russia made a joint statement criticizing the proposal's rejection of the "inseparable interrelationship between strategic offensive arms and strategic defensive arms", its "left-of-launch" capabilities, and its "orbital deployment of interception systems". On 21 May 2025, Press Secretary Dmitry Peskov instead stated that the plan was a "sovereign matter" for the US, and that the legal framework of defunct US-Russia nuclear arms treaties "must be recreated both in the interests of our two countries and in the interests of security throughout the planet". North Korea: On 27 May 2025, North Korea's Ministry of Foreign Affairs criticized the proposal as representing "an outer space nuclear war scenario". It denounced "undisguised moves for space militarization" and argued regional stability requires "the symmetry of the matchless power".
== External links == The Organic Synthesis Archive Total Synthesis Highlights Total Synthesis News Total syntheses schemes with reaction and reagent indices Group Meeting Problems in Organic Chemistry Archived 2012-04-26 at the Wayback Machine
Sources: en.wikipedia.org
Most listings describe it as a short acetylated peptide with the sequence Ac-LKKTETQ, presented as a region of thymosin beta-4. The label is a trade-style name rather than a standardized chemical name, so the exact content of a given vial depends on the supplier.
No. Thymosin beta-4 is a protein of 43 amino acids, while TB-500 is described as a short fragment of it. The two differ in size, structure, and the range of interactions each can support.
Naming for research peptides is not centrally coordinated, so vendors set their own labels and specifications. Differences in stated sequence, molecular weight, or purity documentation usually trace back to those independent labeling choices.
Desiccated storage at −20 °C is conventional, with −80 °C for extended periods. Vials should be warmed to room temperature before opening to prevent condensation on the powder.